Sunbeam Rapier Owners Club
Sunbeam Rapier Owners Club
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Technical
 Information
 fuel problems
 New Topic  Reply to Topic
 Printer Friendly
New posts at top
New posts at bottom
Author Previous Topic Topic Next Topic  

mike L

18 Posts

Posted - 27 Jul 2012 :  22:58:23  Show Profile  Reply with Quote
The following item highlights fuel problems when cars aren't used much.....I had a similar problem with a 2006 DF140 that I bought in July. The boat is a 2005 with 15 hours total. It sat for long periods of time. It would idle fine but as it reached 2400RPM it would miss and sputter like it was starving for fuel. I had the injectors removed and cleaned. There was some obstruction, but it did not solve the problem. My problem ended up being contaminated fuel being in the VST tank. Rather than have it removed,I flushed it with carb cleaner in an involved process, and that ultimately solved the problem. I had to do it twice, but it finally cured it. When I flushed it out , you can't imagine what sort of trash came out. That debris was gathering on the inlet screen on the intake side of the high pressure fuel pump and restricting the fuel flow.

To be able to flow fuel through the VST to flush it, this is what I did. I disconnected the the return fuel line from the bottom of the fuel rail. This hose flows unused fuel back into the VST tank. I plugged the fitting where it attaches to the bottom of the fuel rail using a piece of 3/8 fuel hose with a 3/8 bolt inserted in to it to plug it up. I then used a can of carb cleaner with the small "straw" tube (like on WD40) to spray the carb cleaner up through the open drain line into the VST tank. When I had sprayed as much as I could, I then blew air through the return fuel line to flush the carb cleaner back out of the open drain line. When I did out came a lot of sediment which looked like rust. But I was told by a Suzuki guru, that it was oxidized fuel. At any rate, I did this process several times and now the engine runs like new. I hope I have made the process clear. If not, let me know if you have any questions. If you try this let me know how it turns out.
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
New posts at top
New posts at bottom
Jump To:
Sunbeam Rapier Owners Club © 2024 Sunbeam Rapier Owners Club Go To Top Of Page
Snitz Forums 2000